1、電泳儀通電進入工作狀態后，禁止人體接觸電極、電泳物及其它可能帶電部分，也不能到電泳槽內取放東西，如需要應先斷電，以免觸電。同時要求儀器必須有良好接地端，以防漏電。

2、儀器通電后，不要臨時增加或撥除輸出導線插頭，以防短路現象發生，雖然儀器內部附設有保險絲，但短路現象仍有可能導致儀器損壞。

3、由于不同介質支持物的電阻值不同，電泳時所通過的電流量也不同，其泳動速度及泳至終點所需時間也不同，故不同介質支持物的電泳不要同時在同一電泳儀上進行。

4、在總電流不超過儀器額定電流時(最大電流范圍)，可以多槽關聯使用，但要注意不能超載，否則容易影響儀器壽命。

5、某些特殊情況下需檢查儀器電泳輸入情況時，允許在穩壓狀態下空載開機，但在穩流狀態下必須先接好負載再開機，否則電壓表指針將大幅度跳動，容易造成不必要的人為機器損壞。

6、使用過程中發現異常現象，如較大噪音、放電或異常氣味，須立即切斷電源，進行檢修，以免發生意外事故。